![]() |
|||||||
| |||||||
![]() |
|
|
LinkBack | Thread Tools |
|
(#1)
|
|
(#2)
|
|
||||
|
08-01-07, 05:10 PM
Hi Theresa
I think it very much depends on the solution, but in general, I leave the face until last, and by then time I've done that the rest of the body is dry, and I just give a quick spray of clean air over the face to speed up drying there. Occasionally a client says it feels slightly tacky, but after a couple more minutes there's no problem. |
|
(#3)
|
|
(#4)
|
|
||||
|
08-01-07, 08:02 PM
I do spray tanning mobile and basically advise client to leave clothes off for at least 10 minutes but I tell them if they can wander around in the buff for as long as possible then thats all the better to prevent any rubbing etc.
Most seem to find it liberating that they have a legitimate reason for being stark naked around the house !! |
|
(#5)
|
|
||||
|
08-01-07, 08:43 PM
I have a high quality HPLV machine and my clients don't need to wait at all before getting dressed.....whichever solution I put through it, they are good to go!
I used to use an airbrush and compressor and then my clients had to wait around for ages to get dressed as no matter what psi I set the machine to, it always went on wet. Which machine are you using? If it's either the mini mist or the TC3 your clients should be good to go as soon as you have finished provided you are not spraying too wet, a light mist is all that is required, half a turn-ish with the minimist and a 1/4 turn with the TC3. |
|
(#6)
|
|
(#7)
|
|
(#8)
|
|
||||
|
08-01-07, 09:02 PM
As some of the others have said, with some tanning systems you don't need to wait for it to dry off. We use tantrick and i just give literally 2-3 mins before getting dressed, with tantrick you don't really need to do this but i just like to make sure!!
|
|
(#9)
|
|
||||
|
08-01-07, 09:52 PM
Quote:
|
|
(#10)
|
|
||||
|
08-01-07, 09:57 PM
Quote:
That was what lead to this question! |