Airbrush spitting

SalonGeek

Help Support SalonGeek:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Status
Not open for further replies.

lindag

Well-Known Member
Joined
Feb 16, 2004
Messages
417
Reaction score
4
Location
Dublin, Ireland
My airbrush gun seems to spit out paint. There doesn't seem to be a clog or block has anyone got any idea what the problem might be?
 
Hi,
It could be condensation, if you loosen the screw at the bottom of the water trap container on the compressor when the airbrush is being used, it should spit out the water. Then tighten it up again. I use an Iwata so if may be different if you have another type.

Hope this helps and that I explained ok.

luv Sarah x

lindag said:
My airbrush gun seems to spit out paint. There doesn't seem to be a clog or block has anyone got any idea what the problem might be?
 
I've tried that, thanks though
 
Have you checked to see that the paint isn't too thick ? Or that your air pressure isn't too low? It should be about 25psi when you're spraying the nails.

Hope this helps x
 
Status
Not open for further replies.

Latest posts

Back
Top