Glam spray gun

cloughers

Well-Known Member
Lesley82 please give Dawn a ring in the morning and she'll explain everything. X
 

lesley82

Member
Thanks, I will do :) xx
 

steve@nouvatan

Well-Known Member
ARGHH !!! This is totally my fault, I sent a blanket email out to all the trainers about the settings on the glam machine, what it was supposed to say was gun on 1 and machine on highest setting.. But the way I wrote it, it could of been so easily misunderstood to of meant Gun on highest setting which is 6 and machine turbine on lowest setting. that is what the Liverpool training centre did with you Lesley :rolleyes: the real setting is machine turbine on high, and gun on one. This way you will get the right spray pattern,
I apologise for the confusion, when I am wrong I admit it, like the time I ordered tents in millimeters not centimeters and I ordered 100,000 buffing mitts instead of 1000.... S@@t happens sometimes but most of the time I am epic LOL
 

lesley82

Member
I have just done a tan and put the machine in the highest setting and gun on 1 and it was loads better although I think I might of used a bit too much solution! Hopefully, I'll get the hang of it soon :) xx
 

cloughers

Well-Known Member
I have just done a tan and put the machine in the highest setting and gun on 1 and it was loads better although I think I might of used a bit too much solution! Hopefully, I'll get the hang of it soon :) xx
You'll soon get the hang of it. Do a few friends to practice and ask for honest feedback. Good luck. X
 

dudeymel

Member
I just did an 8% tan on 1 high and I couldn't even see the tan at all so I couldnt see where I had sprayed, I had to spray it on my own arm to make sure it was working, hope it comes out even :/ x
 

cloughers

Well-Known Member
That doesn't sound right. Had you cleaned the gun out after the last time you used it? You should always be able to see the guide colour.
 

dudeymel

Member
I rinsed it through with water, when I sprayed it up close on my own arm and on some couch roll I could see the colour fine it was just when I was spraying it on the client I couldn't, I wasn't stood too far away. Very weird x
 

cloughers

Well-Known Member
You should half fill the cup with warm water after tanning and then spray it through to make sure there's no tan residue left in there.
 
Top