Mistake in my choice of Wax heater?

[Sharon45]

Ladies,
Hope you can help. I'm worried i have made a mistake in my choice of wax heater, i have just brought the Perrin Rigot wax range ie, Cirepil Nacree Blanche & the Euroblonde. So i can offer non strip and strip wax at the same time (as a mobile) i brought the Satin Smooth double heater.

However, HOW do i get the Nacree Blanche wax into the wax heater pot, i have the tin of wax in my airring cupboard as i write in the hope it will warm up enough so i can then pour some in to the heater.

How do you transfere yours?

Shoud i have gone for two hive heaters?

Thanks in advance,
Sharon

Newy to forum and studying NVQ2

 

[ukfaye]

Hi hun im mobile too and do have two seperate heaters, but i have read plenty on hear have the same as you. Im sure there is a way. What about standing the tin in a pan of boiling water to heat it. It takes some heating so may take a while so not sure?? or maybe just get a cheap heater for home just for that job? im sure someone will have a better idea. Sorry hth Faye.xx:hug:

 

[beauty4you]

Will the pot not fit into the heater or are they too large?


I have the satin pro single heater and always wondered if the pot would fit into the heater or if they were too big. I always heat the pot of wax using the babylis or hive wax. 450grm pot I think they are.

sorry I am not really much help

 

[Sharon45]

Thanks for your thoughts, but no the tins don't fit in to the heater.

Sharon

 

[Zo Zo]

If you want to use Perron Rigot then you may be better off with 2x Hive 1000cc heaters. In the meantime, I would recommend you buy some Berins Ease (which is strip wax) as the tin fits perfectly in the Babyliss double heater, then you can use that alongside the Euroblonde.

Many strip waxes will fit the Babyliss heater, just not the PR

 

[Kim Lawless]

No need to change brands. Just tip the can of wax upside down and rest it on the wipe bar of your heater (turned on) and then it will gradually flow into your heater. Keep a close eye on it so that it doesn't overflow. Once it's in your heater, you just top it up in the same way. xxx

 

[Sharon45]

Ahhhhh thank you, I had been told during my training to balance tins on the scrap bar, but when i did this nothing happened (perhaps i wasn't listening when told to turn the heater on!) DOW..

Sharon
xx

 

[fena]

I used to spoon the pr blue ocean into the babybliss. I went through no end of spoons and alot of mess before i got the wax in. ooh the embarrasment now,, pmsl
I took advise from kim and now leave the tin on the scraper bar heater is on low and no problems. lol