Nail Perfection
Well-Known Member
I have had my T200 for about 3 months. I use tantrick. At first it sprayed very well but after a few tans it has become very temperatmental! This is driving me mad as I am a perfectionist and hate the idea of give someone a streaky tan.
After every tan I flush through cold tap water. The water comes out very smoothly so I wondered, at first, if the solution is a bit too thick for my machine as some other solutions seem less oily and spray better. But, then I realised loads of people get along just fine with T200 and tantrick so ruled that out!
I have taken the gun apart and washed following the instructions on the video tutorial. I have also tried using soapy water, followed by clean water but the machine is still not spraying correctly. I wondered if the needle could have got bent at one point but I was very careful when removing it that this is unlikely.
Too explain what I mean, it sprays one minute fine and then nothing comes out the next. I have to spray clients a second time (lightly) to make sure all the area is covered. I have had these problems before with cheaper machines so am disappointed to have the same with this machine.
Any advice would be very much appreciated, thanks.
After every tan I flush through cold tap water. The water comes out very smoothly so I wondered, at first, if the solution is a bit too thick for my machine as some other solutions seem less oily and spray better. But, then I realised loads of people get along just fine with T200 and tantrick so ruled that out!
I have taken the gun apart and washed following the instructions on the video tutorial. I have also tried using soapy water, followed by clean water but the machine is still not spraying correctly. I wondered if the needle could have got bent at one point but I was very careful when removing it that this is unlikely.
Too explain what I mean, it sprays one minute fine and then nothing comes out the next. I have to spray clients a second time (lightly) to make sure all the area is covered. I have had these problems before with cheaper machines so am disappointed to have the same with this machine.
Any advice would be very much appreciated, thanks.