steve@nouvatan
Well-Known Member
A number of you have noticed a shadow on the floor after using the TS20. this is caused by the air and spraytan solution overspray being sucked into the machine via the air intake. and as the casing is not completely air tight around the power flex entry a small amount of tan is deposited on the floor around the machine.
I have found that if you place the base unit at the rear of your cubicle. and feed the hose through the flap at the rear. then the machine is sucking clean air from the back of the room and not sucking the overspray out of the cubicle and depositing it on the floor around the base unit.
This solves the problem also a little ring of black tape on the electric flex where it enters the plastic/rubber sleeve on the base unit, greatly reduces the overspray leakage from this machine
Happy to help
I have found that if you place the base unit at the rear of your cubicle. and feed the hose through the flap at the rear. then the machine is sucking clean air from the back of the room and not sucking the overspray out of the cubicle and depositing it on the floor around the base unit.
This solves the problem also a little ring of black tape on the electric flex where it enters the plastic/rubber sleeve on the base unit, greatly reduces the overspray leakage from this machine
Happy to help