It doesn’t have a choice of temp, I left it for ages to warm, I wondered if it was because it was a cheap unit it just isn’t up to the job
Must’ve been on an hour to heat up, I put it on while I was doing other things, maybe I wasn’t holding at the right angle? I really want to get this right because I’m a messy waxer !
I have the clean + easy roller system and I would always give it an hour minimum to heat up.
For normal daily use I put it on 2 hours before the first client which ensures the temperature has evenly settled.
Set the correct using temperature and leave it to heat up - don't put it on high to start with.
It doesn’t have a temp control, it’s just on and off ! Apart from the wax being too cool would there be another reason for the skin pulling ?
This is my 2nd one because the first was faulty, I guess you get what you pay forI can't think of another reason.
The wax should hot enough to be runny and flow through the roller head smoothly.
Perhaps you have a faulty heater?
Return it to your supplier as not fit for purpose.
Enter your email address to join: