Applying Gelbond

[Becky_simon]

Hi ladies

I normally use a liquid adhesive applying with a brush.

With Gelbond do I need to apply it so it fills the well of a tip/the whole area of an non-blend tip? Or do I just need to apply it in the centre and it pushes out?

Thanks

 

[Becky_simon]

Anyone?

 

[SweetyStacey]

Personally I cover the whole well to ensure maximum adhesion..sometimes if I don't cover it enough it won't adhere so I just cover it all to make sure.

 

[Melissa82]

Found online:
Directions:

Remove nozzle and cap and puncture seal with a straight pin. Replace nozzle only.
Place bead in contatct are of tip (squeeze tube on the upper third, NOT the bottom to eliminate oozing). Spread to coat entire area.
Wipe tip onto nail plate to coat.
Hold tip at 45 degree angle and butt stop to free edge of nail.
Firmly press tip contact area to nail. NOTE: To remove, soak in Product Remover for 2 to 3 minutes.

 

[Becky_simon]

Thank you ladies